Most Mobridge Instrukcja Użytkownika Pobierz pdf (Strona 2)

Never bend fiber optic lines sharply (acutely) or at more than

about 2” radius or permanent damage may result to the fiber.

Battery power (+) to the unit must be fused by a value of 5A.

On a 10A circuit or the radio’s circuit is acceptable (safe, OK).

Power to mObridge must be constant battery (B+). It cannot

be from a vehicle power plug. Vehicle power plug is not

consistently constant power, despite appearances or first

apparent behavior. Best location to source power is at the

Head Unit’s own power or CD changer’s power wire (e.g., in

Porsche red wire with yellow stripe).

If vehicle is intended to be serviced (diagnosed) by the dealer,

bypass switch should be put into the ON mode. It is not plug

and play (vehicle power cycle must be done / complete sleep/

wake cycle in order to properly initialize MOST bus in

mObridge’s bypass / non-bypass mode.

Same goes for first installation / or replugging mObridge into

vehicle after disconnection. MOST bus is not hot “plug and

play”. Do not expect system to immediately work after

plugging in units and turning on vehicle. If any MOST piece

has been disconnected, vehicle must go though a complete

deep power cycle to reinitialize the MOST bus properly before

operation will normalize again.

page 2 of 14

1 2 3 4 5 6 7 ... 13 14

Brak uwag

Most Mobridge Instrukcja Użytkownika Strona 2